4 channel footswitch JVM210C
0

votes

Can the foot switch be programmed to not remember settings on each channel, only the basic pre loaded ones? Meaninig that if it remembers that I had reverb on channel 2 of the clean sound, I dont want it to turn reverb on next time I cycle through to that channel. 

asked 10 Apr 2023 at 03:35 PM

Mark Dalrymple
Answers: 1
0

votes

Hi Mark,

If you have a footswitch button changing channels or modes it will remember the reverb state of which it was stored. This means it will recall whether the reverb was on or off so you would need to then switch you reverb to the desired state.

Regards

Marshall Support

answered 17 Apr 2023 at 10:32 AM

Loading - please wait...
This site uses cookies to improve your experience. By continuing we assume that you're ok for us to store cookies on your device. You can change your cookie settings at any time, or delete cookies, by going to our cookie consent page.