This is not a question but a response to those who have asked if there is a way to reduce the output wattage on Code amps to make them quieter. The short answer is no, not out of the box.
However, the speaker(s) that come with Code amps are 4 ohm. In the case of the Code 25, you can swap it out for a Celestion G10N-40 10" 8 ohm speaker (about $70 on Amazon) and reduce the output from 25 watts to 12.5 watts due to the change from 4 ohms to 8 ohms. Instead of running the master volume at < 1 when I'm jamming with my stereo, I can now run it at about 3. The added bonus is better sound - you hear the distortion from the amp itself with less mud and distortion from the speaker. This will not harm the amp in any way as driving an 8 ohm load requires less of an amp than a 4 ohm load.
Full disclosure, this was not my idea. I read about this from another Code 25 owner. Enjoy!
Changing the speaker in the Code 25 seems like a fix the end user shouldn't have to do, and which will probably screw up the modelling.
I'm experiencing the same problem with my brand new Code 25... Hardly any sound until almost 1.0 on the master volume, then suddenly too loud for my apartment.
Rather than changing speakers at our expense, Marshall needs to stand behind their product and issue a firmware upgrade that will fix this. How did such a problem make it past the design stage and into production? I love the sounds this amp can produce, but I'm disappointed I don't have any kind of rational volume control.
The OP is correct. In fact, I am going to use a Celestion G10 Greenback @ 16 ohms for a 6.25 watt power output. The Greenback is rated at 95db 1watt/1meter so max SPL on my Code will be about 103db. Overimpeding a solid state amp has no detrimental effect and may actually make it more reliable. Less watts = less heat. Don't do this with a tube amp, and don't put a 2 ohm load on a SS amp rated at 4 ohms.
Hi, this is something I have struggled with my cider since I got it so I will defenatly give this a go. can I just ask why you chose this particular replacement speaker (celestion G10 N-40) I haven't got experience with speaker and with so many choices on the market how did you come to this one.
Cheers for the post with a bit of luck I can tame my code25 for home use.
OR: you could simply dial down the Preset Volume for each preset (just answered, YET ANOTHER, question about this).
P.S. Just to add: the obvious problem with this is that the speaker cone is barely moving so you're missing out on that wonderful tone that can only come from the speaker at a reasonable "tilt". Not sure if replacing the speaker as suggested here will improve on this though. Could do.