Dsl40cr issues?
0

votes

Hi there,

I had a Marshall dsl40cr brand new and out the box it "hissed" and "wooshed" quite bad, so much so I had to send it back.

I was sent a replacement that was alot better, but still a touch of noise.

This isn't electrical noise or interference - I know what that sounds like - this is something different.

It's only recently I've been too bothered, as it seems a lot of people have this issue.

My second issues is, when swapping between the 2 master volumes there is a popping noise - that's regardless of if 1 is higher than 2 or vice versa. It's like a static pop and happens via footswitch or on the panel.

I been reading the noise can be due to caps and resistors that need swapping and the popping is due to a faulty controller. Surely if these are known problems, this should be covered.

Any help is greatly appreciated!

Thanks!

asked 13 May 2020 at 02:38 PM

Nathan Martin
Answers: 1
0

votes

Hello Nathan,

 

The noise is due to the gyrator circuit that is built into the amplifier to give a better bass response, this should not be heard whilst playing, due to it being a high gain amplfiier there is a slight pop when changing channel, this is not a fault and isn`t causing any damage to the amplifier.

 

Kind Regards

Marshall Support

answered 14 May 2020 at 10:23 AM

Marshall
Loading - please wait...