Questions
Showing results 1 to 4 of 4
0

votes

0

answers

22

views

Sometimes it works, sometimes not.  I have to fiddle with the input cable.

How do I replace the input jack on my CODE50?  Does it simply unplug/plug into the PCB?

Where can I get the part and a diagram?

Thanks.

 

asked 11 Jan 2021 at 03:55 PM

Steve Cuoco (2)
0

votes

2

answers

834

views

Hello. I've lately been having difficultys with my MG50DFX Marshall amp. The problem is, is that the input jack will refuse to make a connection unless I hold the quarter inch jack up. I don't know much about amps and I'm hoping this is a simple fix. I've already taken the amp's motherboard out from the cabinet and taken the piece of plastic off of the top of the jack. I've attempted to bend the 2 metal pieces that make a connection to the male jack down, but to no avail. It still refuses to make sound without me holding the wire up; otherwise, it'll just make feedback. Any ideas?

asked 01 Oct 2017 at 09:45 PM

nonya bidnet
0

votes

0

answers

686

views

I tried the factory reset. It seems the only thing that did was wipe out my presets. It did absolutely nothing for the noise from the input jack. The noise is like 60 cycle hum on steroids. I've tried four different cables that were dead quiet when plugged into my other amps.

asked 22 Jul 2017 at 02:17 PM

Scott Waters
0

votes

0

answers

1k

views

Today I tried to connect my guitar via iRig and a common audio cable to my Code 50.

The sound was really muddy without any treble... Same when I play music from my phone over the audio input... 

Can anyone confirm this?

And is there a way to control the input volume?

Thanks and regards 

Seb

asked 04 Jul 2017 at 09:40 PM

Sebastian Bayer
Showing results 1 to 4 of 4
Loading - please wait...