I got a CODE100H and the manual says that you never must run the amp without an cab connected. But there are so many videos and tutorials where the amp is plugged only via USB or headphones. Does it make a difference if is there's a DAW, a cab or headphones connected?
And another problem is the delay while connected through USB. How can this be solved?
I have tried everything to do the firmware update on my new Code 25. Its showing v1.11 still.
I have tried Crome, Edge, and downloading the manual windows exe. I have updated drivers, booted amp in "safe mode" (which identified usb as READY but still wonnect connect in My.Marshall
Please help! I love the amp but need to be able to update the firmware
I just got around to updating the firm ware on the code 100 thought as long as i had the amp connected to my pc via the usb cable I would check out the code editor and it would not respond looked at the manual casually and did not notice any mention of how to connect
dos this need to be acomplished using a midi to usb cable
OK, I did all this (from my last question) and read the 4all manual. I think I set it up correctly using the 4all Control Panel and changed the asio driver in my Cubase control panel, but still no signal. I really don't get it. Do I still need to rout it through my interface? Does my interface that shows up in the 4all control panel need to be clicked on? and if so then, how does that need to be set up in this situation? The 4all forum in mtippach.proboards40.com does not let me register, or ask a question and this particular application is not addressed. Thanks, kevin - kevin hughes 24 Feb 2018 at 11:31 AM