Questions
Showing results 1 to 3 of 3
0

votes

1

answer

66

views

How can I update firmware when I don't have USB port on my Marshall speaker

Speaker USB Firmware

asked 16 Jul 2019 at 09:23 PM

Sheilah Williams
0

votes

1

answer

94

views

I'm using USB on my Mac and the Mac sees the Code and allows me to set the speaker to it.
When I pull up a Youtube video and start it the video will play for about 5 seconds and then halts.
It's almost like something else is intercepting it. It basically locks up and I have to close the browser.

Same issue when using the Code 25 as input device on Mac for Garage Band. It recognizes it but when I record
upon playback the sounds are scratchy and unusable

This Code 25 works on my Windows Machine both ways as Input and Output device flawlessly

I have installed the latest firmware so that is not the issue.

Any ideas on what it might be causing the problem on the Mac?

--Pat Brown

CODE Speaker Mac USB Firmware

asked 05 May 2019 at 04:55 AM

Pat Brown (25)
2

votes

2

answers

315

views

Actually I'm totaly not interested in bluetooth connection, but of course I understand that it might be an essential prolem for some people...

But there are some other problems I'd like you to find good solution for.

1. Master volume. From 0 to 10% there is almost no sound, over 10% it becomes very loud. 

2. Decreasing sound level with Volume pot results in decreasing USB signal level - not acceptable for players using USB output for recording in DAW software. It would be nice if for clean preamp gain at 2 and volume at 3  give recording level about -6 dB, now it is about -36 dB... 

Best regards, Jacek.

P.S. What is a frequency range of CODE 25 speaker?

 

CODE Bluetooth Speaker USB Firmware

asked 24 Jan 2019 at 11:09 AM

Jacek Klimkiewicz (122)
Showing results 1 to 3 of 3
Loading - please wait...