I seem to be having the same issues that a lot of people have reported, where I cannot get the Marshall Gateway app to connect to my Code 25. I've only had the amp for about a week and I cannot get the app to see it. ?
I can connect to the amp via Bluetooth using my phone (Pixel 3a, Android 11) and whilst connected, can use it as a BT speaker to play music from Spotify. However, nothing I do seems to get the app to connect to the amplifier.
-I've updated the amp to the latest firmware using my laptop/web browser.
-I've followed all the instructions in the Bluetooth Connectivity Troubleshooter to the letter (CODE - Gateway Bluetooth Connection Troubleshooting - my.marshall.com)
No matter what I do, or what order I install/uninstall/connect, the app will not see the amplifier. Everything works otherwise - I'm able to apply Patches from ? using a USB connection - and the amp sounds great. I'd just like to be able to control it from my phone.
Quick 4 part question: A) can I use the USB to get a line level signal into my PC that my digital interface will push to my powered monitors?
B) when using USB is the cabinet speaker muted?
C) must my DAW be open to make this work?
D) in this USB mode, can the CODE 100 be operated without speakers connected?
I'm using USB on my Mac and the Mac sees the Code and allows me to set the speaker to it.
When I pull up a Youtube video and start it the video will play for about 5 seconds and then halts.
It's almost like something else is intercepting it. It basically locks up and I have to close the browser.
Same issue when using the Code 25 as input device on Mac for Garage Band. It recognizes it but when I record
upon playback the sounds are scratchy and unusable
This Code 25 works on my Windows Machine both ways as Input and Output device flawlessly
I have installed the latest firmware so that is not the issue.
Any ideas on what it might be causing the problem on the Mac?
Actually I'm totaly not interested in bluetooth connection, but of course I understand that it might be an essential prolem for some people...
But there are some other problems I'd like you to find good solution for.
1. Master volume. From 0 to 10% there is almost no sound, over 10% it becomes very loud.
2. Decreasing sound level with Volume pot results in decreasing USB signal level - not acceptable for players using USB output for recording in DAW software. It would be nice if for clean preamp gain at 2 and volume at 3 give recording level about -6 dB, now it is about -36 dB...
Best regards, Jacek.
P.S. What is a frequency range of CODE 25 speaker?
If I want to plug my 100h into my PC via USB, does it still need a speaker load or can I use it without a cab connected?
CAN I ADD ANOTHER SPEAKER CABINET TO THE CODE 50
I WOULD LIKE BOTH CABINETS TO PRODUCE SOUND
MAYBE THROUGH THE USB OR A PORT OUT OR A WIFI CONNECTION
The Code 25 makes a strange sound when letting a plucked guitar string sound die out, only when "amp" is selected (might be digital artifacting?) I saw one question about this via USB, but what I hear is not via USB, just out of the amps own speaker, no USB connected!