Hi. I just bought Marshall 1959 HW and it's constantly humming when it's on. I have Wizard Modern Classic Amp and ENGL Powerball 2 and they don't hum like that when ON. Is it normal? Also when I strum a chord very loud mechanical noise going out of the back. Check the video I shot to hear how both issues sound:
Hi,
I recently bought a Marshall DSL20HR head and a Marshall 1936 Lead 2x12 cab.
The head has a cab emulator out, so I hooked it up to my audio interface and was playing through my pc monitors. I turned up the volume and gain on the ultra gain channel and a strange buzz/noise came from the head when I would strum a chord or pick a note.
I only noticed this because I had the level on my interface low as I was just testing the cab emulator out. I have alos tested this with the head not plugged into either my interface or the cab and still get a strange noise/buzz.
As this is my first valve head I'm not sure if this is just something that happens when you turn up the volume and gain - as the amp is being pushed harder, or if there is a fault with the head and I need to take it back to the shop I purchased it from.
I will link below some video of the problem. The first video sounds worse than it is as I put my phone directly on top of the head as I play. It's not the signal noise from the amp that I am worried about, it's the rattle when I strum chords or hit notes...
https://www.youtube.com/watch?v=CWTiPugPfZ4
Any help would be greatly appreciated, I'm probably just over reacting, but it would be good to get some reassurance.
Thanks! \m/