I had a Marshall dsl40cr brand new and out the box it "hissed" and "wooshed" quite bad, so much so I had to send it back.
I was sent a replacement that was alot better, but still a touch of noise.
This isn't electrical noise or interference - I know what that sounds like - this is something different.
It's only recently I've been too bothered, as it seems a lot of people have this issue.
My second issues is, when swapping between the 2 master volumes there is a popping noise - that's regardless of if 1 is higher than 2 or vice versa. It's like a static pop and happens via footswitch or on the panel.
I been reading the noise can be due to caps and resistors that need swapping and the popping is due to a faulty controller. Surely if these are known problems, this should be covered.
Any help is greatly appreciated!
Hello, admin, why you delete my posts? I bought an expensive amplifier that is noisy and I need a solution to my problem.
I can not send the amplifier back due to the rules of the customs of Russia. It turns out too expensive.
I ask technical support to help me solve the noise problem in the new amplifier. You are, after all, Marshall, not Noname Firm.