I took delivery of a Code50 last Friday, and already I have noticed a major flaw. I have updated the firmware, and it didn't solve the problem.
1. On many of the presets, there is what sounds to me like a slight buzz or a distorted sound as the chord is being held after about 4 or maybe 5 seconds. Obviously, this isn't going to be good when recording.
For example, I have been using many of the clean sounds, such as, American Clean (preset 32). This is a prime example of the unwanted buzz as the chord fades (only 4 or 5 seconds). There are so many more presets that also have this problem.
The issue occurs through both the Code50 built-in speaker and my Beyer Dynamic DT100 headphones. Using headphones proves that it is not the internal speaker at fault.
I can email a sound byte if you need one.
The last thing I want to do is re-box the amp and return it for a replacement only to have the same issue happen with the next unit. So, please can you let me know if this is a widely known fault because, if it is, I will unfortunately have to send it back for a full refund.
2. A second issue worth noting here is that the clean sounds are not very loud. When wearing headphones, I have to increase both volumes to 10, but I can still hear the strumming of the actual guitar with my plectrum coming through the headphones. The volume on the clean sounds are too weak and definitely not loud enough when also playing through the Code50 speaker, not just the headphones. Conversely, the distorted rock sounds are really loud when the volume is set to a low level, but the clean sounds couldn't be more opposite.
It will be a shame if I return the unit because I love the app and the ability to back up presets and also search for new ones.
Hi. I just bought Marshall 1959 HW and it's constantly humming when it's on. I have Wizard Modern Classic Amp and ENGL Powerball 2 and they don't hum like that when ON. Is it normal? Also when I strum a chord very loud mechanical noise going out of the back. Check the video I shot to hear how both issues sound:
I recently bought a Marshall DSL20HR head and a Marshall 1936 Lead 2x12 cab.
The head has a cab emulator out, so I hooked it up to my audio interface and was playing through my pc monitors. I turned up the volume and gain on the ultra gain channel and a strange buzz/noise came from the head when I would strum a chord or pick a note.
I only noticed this because I had the level on my interface low as I was just testing the cab emulator out. I have alos tested this with the head not plugged into either my interface or the cab and still get a strange noise/buzz.
As this is my first valve head I'm not sure if this is just something that happens when you turn up the volume and gain - as the amp is being pushed harder, or if there is a fault with the head and I need to take it back to the shop I purchased it from.
I will link below some video of the problem. The first video sounds worse than it is as I put my phone directly on top of the head as I play. It's not the signal noise from the amp that I am worried about, it's the rattle when I strum chords or hit notes...
Any help would be greatly appreciated, I'm probably just over reacting, but it would be good to get some reassurance.
The noise comes and goes the more I play.
I love the sound of this amp but can't get rid of this noise.
A couple of weeks ago I bought aforementioned amp. I was very happy with it, no issues so far, but today while playing I noticed a weird buzzing sound that my amp makes whenever I play an A note on my guitar. I tried different fret position, plugging in my other guitar and even moving the amp in case something else than the amp itself was making the sound. Nothing helped. Did anyone else had a similar problem? Any ideas what might be causing it?