Questions
Showing results 1 to 2 of 2
0

votes

0

answers

456

views

Hi, I'd want to know if disconnecting the speaker on a 20w Origin head would activate the standby (so this won't damage the amp) even if then I go through the send to an audio interface and not returning to the amp through the return or anything else (and so NOT using the di out). In fact I would like to use my favorite cab+microphone+power amp simulator and then connect it to the interface and listen with my headphones on and I think it would be impossibile and harmful to the sound to add another cabinet simulation to the already-present One in the di out (right?) and so I would exit from the send.

2 another simple questions:

could i do this with a combo, too? In that case, how do I disconnect the speaker?

The last one: if I exit from the send, I'll take the preamp signal, right? And if I exit from the di out will I have the preamp signal (with the cab simulation) or will it just be the guitar signal with the cab simulation only (I assume I won't anyway have the power amp too)?

Sorry for my bad english and for the ignorancešŸ˜…

 

edited 11 Jan 2021 at 10:45 AM

Jacopo Gaggia

asked 11 Jan 2021 at 10:17 AM

Jacopo Gaggia
0

votes

0

answers

938

views

Hello I'm considering to buy DSL1HR or CR for silent recording at home. But I would like to use fx loop SEND output to record raw valve soud to apply impulse response later.

 

Is it safe to unplug cabinet, and without connecting headphones use these amps in such manner? 

And if so, why? Usually valve amp needs speaker load

 

Thank you in advance for the answare!

Sergey

asked 04 Dec 2019 at 12:44 PM

Sergey Tereshkin
Showing results 1 to 2 of 2
Loading - please wait...