I have Marshall CODE50 and PEDL-91010 (2-way switch). I have the latest 1.44 firmware update installed, but my pedal does not work properly. For some reason when I press the switch to go down a preset it goes up a preset or just does nothing. Sometimes it works, but that does not happen very often. I've opened the footswitch and the circuit seems too simple to be faulty and by the way my amp acts when I press the down switch it looks like it is the problem with the firmware.
Hi i have a set of combined issues with my Code 50 with the 4 button footswitch
First of, love the products!
But my issue with it is major! I cannot set any preset on my footswitch, It seems so easy on the tutorials but mine just keeps on switching back to the preset that already was on the button (1,2 or 3). I do as followed. I chose the preset i want on ex.button 1, so i hold the "store/exit" button for 2 seconds and then i push the 1 button on the footswitch. But it only changes back to the preset it WAS. So no changes. When i HOLD the "Store/Exit" button for too long (3a4 sec) then it says "stored" and then no sounds comes out of the amp anymore, i can push the REV and AMP buttons and the LED light up. But no sound! The footswitch also then doesnt butch. I have to restart the AMP to get it to work again.
I tried to update the firmware but it already was up-to-date so i reinstalled the latest firmware again. I also tried to reset the AMP back to the factory reset but the problem still exists.
owned a code 25 for a while now but only really started using it during lockdown but have to say I'm really impressed. I'm just using it for living room playing and connected to my DAW as a way of laying down ideas but seriously, it's REALLY good.
For context, I've played guitar for 27 years and working in live music has been my primary source of income (pre lockdown....) for around 17 years. I'm usually a live-sound engineer and tour manager and occasionally fill in the gaps with some guitar-teching. I'm uk-based but have international clients, mostly guitar-based, playing mostly academy sized venues but have done major festivals worldwide and one short stint of an arena tour. The point here is not to blow my whistle, simply to say I've spent a lot of time being exposed to all manner of amps and modelling.
I own a line 6 helix and while the CODE isn't as flexible with regards to I/O, I genuinely feel like it's amp-modelling, especially for crunch, fuzzy or blown out tones, blows the Helix out of the water. Not that I'm as likely to use metal tones or had much cause to tweak them but I've noticed those kind of presets can sound a little thin. Also, higher gain sounds in general could benefit from a graphic EQ somewhere in the modelling chain, as it can be prone to squeak at frequencies usually outside of a regular amps range, presumably because of the full-range nature of the cab.
So, my query is, is there any chance that the CODE range is likely to get any substantial firmware updates or maybe 2nd generation hardware that could bring additional functionality/Pro level durability and a decent footswitch... I'm impressed that you've managed to get that much functionality out of a mono-jack but a few extra switches or even just midi connectivity for use with after market footswitched to access would open the amp right up.
Personally, I'd love to see one capable of more complex I/O routing i.e. the ability to record your dry input to DAW over usb and similarly, route from the DAW to the amp input for re-amping.
Midi I/O and an xlr input with phantom and a decent sounding pre would make it a nice little hub for a solo recording setup.
Anyway, great work Marshall/Softube, really hope you develop the line further.