I have had my Code 50 for a while and have played around with it to no avail. It's 20-50X too loud. When I set the Master Volume control to something like .5 it's way too loud. I can adjust the volume within the preset but if I change to any other preset it almost knocks my house over. I think this amp is unusable and has some serious design flaws. Is there a way to knock down the volume for the entire amp and all the presets? I need them all set at around a .1 or .2.
I took delivery of a Code50 last Friday, and already I have noticed a major flaw. I have updated the firmware, and it didn't solve the problem.
1. On many of the presets, there is what sounds to me like a slight buzz or a distorted sound as the chord is being held after about 4 or maybe 5 seconds. Obviously, this isn't going to be good when recording.
For example, I have been using many of the clean sounds, such as, American Clean (preset 32). This is a prime example of the unwanted buzz as the chord fades (only 4 or 5 seconds). There are so many more presets that also have this problem.
The issue occurs through both the Code50 built-in speaker and my Beyer Dynamic DT100 headphones. Using headphones proves that it is not the internal speaker at fault.
I can email a sound byte if you need one.
The last thing I want to do is re-box the amp and return it for a replacement only to have the same issue happen with the next unit. So, please can you let me know if this is a widely known fault because, if it is, I will unfortunately have to send it back for a full refund.
2. A second issue worth noting here is that the clean sounds are not very loud. When wearing headphones, I have to increase both volumes to 10, but I can still hear the strumming of the actual guitar with my plectrum coming through the headphones. The volume on the clean sounds are too weak and definitely not loud enough when also playing through the Code50 speaker, not just the headphones. Conversely, the distorted rock sounds are really loud when the volume is set to a low level, but the clean sounds couldn't be more opposite.
It will be a shame if I return the unit because I love the app and the ability to back up presets and also search for new ones.
I have a Marshall Code 50. Not sure what’s happened but when I plug my guitar into it, I get no sound and the presets are now being controlled by the guitar volume knob. If guitar volume is full high, display on the Code quickly scrolls thru presets. If guitar volume is full low, you can individually scroll thru presets by quickly turning volume knob up then quickly back down. No volume from cabinet regardless of preset volume or master volume, only static. Have tried with both electrics I have and both cables, in various configurations with no difference.
Any help is greatly appreciated.
The problem is that when I put the distortion pre fx my amplifier does not give the sound even with any preset, the other effects work correctly only the distortion does not, however when I connect my headphones I get the distortion sound but without the headphones it sounds
Hi, i am using a code 50, and i cannot store the vlume levels in presets.
I am using 3 diferent presets, but i cannot level the volumes, i think that CODE dont store that.
How can i solve this ?? Its very importan, otherwise its a complete mess....all the presets with diferente volume levels....
Please HELP ME !!!