I have been experimenting with the DI out on my SC20H. In the manual it says it is an "emulated loudspeaker" output however it sounds terrible direct into my DAW. Once paired with a IR it sounds pretty good so I am wondering if this is an error in the manual or if it just sounds bad and should be avoided?
I am having trouble confirming if a speaker must be connected in order to use the D.I out on my Marshall 2525h. The manual only contains one sentence of information which doesn't provide enough clarification considering this can destroy an amplifier if misunderstood.
Would I have to connect my 2525h to a 1x12 cab (via 1x8 ohm connection) in order to use the D.I output? This signal from DI would be sent to a Two-notes C.A.B.M for Impulse response, before going straight into the audio interface?