Hi,
I tried to update my Code 50 firmware. Everything was ok till 100% but finally failed to complete the update.
I did every process advised to fix but I’m stuck.
I can’t reset the firmware even if I reboot.
The only message I have on the screen is on the one hand “no USB connection” or “ready to update”.
What can I do to get my amp working again?
Thanks
Best Regards,
Jérôme
I had the same problem updating from an imac with MACOs with Chrome, and everything was solved by updating the firmware from a Windows PC with Chrome
Well I have the same problem. Older iMac with OSX Catalina. I tried with Chrome, Safari and even Edge which is now available for Mac. Allowed Midi on all of them. Bought a new cable. Nothing worked.
The amp is now unusable and stuck at "CHK USB" and I don't have access to a PC and am not planning on buying one just for this.
The update seemed to work to a certain point counting up from "PROG: 01" and then getting stuck at "PROG: 98". It also gave me an error in the browser that the update did not complete.
In the update window it also shows as connected but when I go to the presets it says "CODE: Not connected " in the lower right corner.
Any solution to this would be very much appreciated.
I had the same problem updating from an imac with MACOs with Chrome, and everything was solved by updating the firmware from a Windows PC with Chrome