Hi.

Just a warning (possibly more a bit of advice maybe):

I noticed over the weekend that sometimes (not always) when retrieving a patch from a CODE amp. the Marshall CODE PC Editor does not always get it right.  Sometimes it will load perfectly and other times it's almost as if it's retrieved some, not all, of the settings for the patch.  I only noticed this after retrieiving some presets, making a change or two, and then overwriting on the amp. with the incorrect settings and I thought I was going bonkers because I checked and re-checked what I was doing but whenever I saved on the amp. sometimes one or two of the parameters were not as I set them.  It seems to do the same when loading a saved patch from disk too.  Wasted hours!!!

Anyway: the easy workaround really is to just keep clicking on the retrieve button until there are no more changes to any of the parameters of the preset being shown on the screen (normally only need to do it twice but three is a lucky number).  Make your changes then save back to the amp. (I've resorted to doing this three times too just for safety sake).  And when loading from disk: get into the habit of doing it three times too!!!

I'll try get their support to have a look at it (although things seem every so quiet over there).

I mention the above because even although we all know the this is not a Marshall Amplication PLC product and is not supported by them: it is indeed punted on these forums quite widely (by myself too).

Regards,

Dale.