My 100h code remains on the display: Ready for update
0

votes

Bonjour,

I have updated the firmware of my CODE100H, but it remains on "Ready for update"
The computer displays the display "Restarting CODE please wait"
I restarted the update but the problem remains.


In advence, thank you for your help.
Walter


 

CODE Firmware

asked 13 May 2019 at 09:36 AM

Walter Bruder
Answers: 2
0

votes

Hi Walter,

Can I ask what browser you are using, I would suggest using Chrome, and make sure the browser has the correct Midi.

https://my.marshall.com/support/faq/839/browser-midi-troubleshooting

Marshall Support

answered 15 May 2019 at 12:49 PM

Marshall
Oups, I did not specify that I had used Chrome and the Reset on the AMP button does not work. - Walter Bruder 16 May 2019 at 07:18 PM
thank you for your help, do you have another solution? - Walter Bruder 16 May 2019 at 07:19 PM
The MIDI was working well because I had already programmed some sound - Walter Bruder 16 May 2019 at 07:20 PM
Hi Walter,

If you turn your Code off, then when turning it on hold down PREFX, MOD and REV, this will load in boot load and give you the amp details under M ,it should say M1.41 then the update is complete

Marshall Support
- Marshall 17 May 2019 at 08:02 AM
0

votes

I turned off my code 100, I held down PREFIX, MOD and REV during the reboot, the screen had not changed.

I redid the update and it restarted normally.

It is now working properly.

Thank you for your help.

answered 12 Jun 2019 at 12:35 PM

Walter Bruder
Loading - please wait...