Looper BOSS and code 25
0

votes

Hi,

I can't have a good sound when i'm using my RC Boss looper.

When I change preset, the sound of the looper, and especially the percussion, are inaudible.
Is there a way to keep the sound recorded normally?
For example if I record my loop in CLEAN, and then I switch to disto.

Thanx :)

CODE Presets

asked 15 Jan 2020 at 11:12 AM

Fabrice lemmel
Answers: 1
1

vote

There is one general rule: looper MUST be the last in effects chain.

answered 15 Jan 2020 at 12:16 PM

Jacek Klimkiewicz (134)
Okay, thanks for answering. So if I understand correctly, will plugging the guitar into the looper which is itself on the CODE input still sound bad? - Fabrice lemmel 15 Jan 2020 at 01:12 PM
In this configuration both looper signal and guitar signal will be processed with the same preset.

CODE is not intended to use with looper. If you have another amp you can try to connect your guitar to CODE input, then connect phone output to looper input (you need a special cable to do this) and then looper output to another amp input. Yoyr CODE amp will work as a multi-effect processor.
- Jacek Klimkiewicz 15 Jan 2020 at 04:09 PM
Ok, i understand :( aie aie :):) - Fabrice lemmel 15 Jan 2020 at 04:27 PM
Loading - please wait...