I've had my Code amp for a couple of weeks and managed to connect it to my iPhone which is running the latest ios 10.2.1. I also got it to connect to a brand new Samsung Galaxy Tab A running Android 6.0.1. The connection didn't always work and sometimes dropped out. I've updated the Amp to the latest firmware to hopefully cure the connection issues and now my phone and tablet just can't detect the amp at all. I've tried turning on and off, resetting everything, forgetting the device etc. etc. but it's like the amp just doesn't have Bluetooth. As no device can see the amp then Gateway just isn't possible to use as it also can't detect a phone or tablet. My devices can see each other but it's like the Amp just doesn't have Bluetooth. I've also tried searching for it with an Ipad but this also couldn't see the Amp ? It looks like the Bluetooth has died on the Amp but thought I'd ask if anyone has any ideas of anything to try or otherwise I'll have to take it back to the dealer and either try another one or replace it with a Fender Mustang. It's a good amp but seems to have to many glitches at the moment looking at the forums. I'll give it one more go though if anyone has any suggestions to try. Any ideas anyone ? Many thanks for reading.
Thanks for the responses. I think it is a hardware issue though with the bluetooth just not working on the Amp. It doesn't seem to matter what device I use the amplifier just isn't visible to anything ?
Hello!
!!! Ok, my bad. Figured it out. Had to put the amp in pairing more (Rev & Power) - then all is well. Sorry. !!!
(Feel dumb, bt I'll leave this in case someone else has similar issue.)
I had the amp successfully paird with a prior phone (Moto Droid as well - 2 yrs old?) Got a new phone - described above - Android v7. Not able to pair. Have uninstalled the Gateway app, (that got in the way last time, until the phone & amp were paired, then an install / connect went fine). This time... I get a cryptic, possibly IP6 number that looks like a device address. No code to enter, or anything to do. Phone says "Pairing..." waits maybe 10 seconds, then returns with "Pairing..." gone - no message, no nothing. Tried many many times. Cannot "forget the device" - phone doesn't offer a lot of choices: pair or disable Bluetooth is all...
Will the Code work with this phone? IS there a trick I hope I don't know? I sort of like the app - although I often use the knobs - it's just easier... So... I'm not going to hate you forever, but have to join the folks that are dissappointed with this. Amps are marvelous, but this software isn't measuring up I'm afraid.
Anyway, any help much appreciated!
Thanks
Steve
Hello !
Like many of lucky owners of Marshall Code 50, I also have problem to pair Gateway app with Code. My phone (Ulefone Power with Android Mashmallow 6) recognize amp thru bluetooth and even play MP3 music, but can't work with Gateway. I wonder why ? I tried to rebooth code and phone several times, also install and uninstall app few times, but nothing helps. I upgraded firmware on my Code 50, still nothing. Can i expect fixed new version of gateway soon, and will it be tested on more smartphone brands ?
greetings from Zagreb/Croatia
Tvrtko Grgic
tgrgic@hotmail.com
Hi there Marshall team,
I was wondering if you could help me with a problem that I am having between my Code 25 amplifier and the Gateway app. I am able to pair my android device and the amp via Bluetooth just fine but once I am in the Gateway app it doesn't detect my amp at all, even when I press "scan for amp" it just says no amp detected.
I think I should add that I have been able to connect it to my apple device without any problem at all.
It would be highly appreciated if you got back to me.
Thank you.
