I have a DSL 100 And a DSL 100H , will the footswitch for the 100 work with the 100H or do I have an issue because mine is not working in the H ?
I just did the latest firmware update on my Marshall Code 50. My headphones suddenly do not work when I plugged them into the jack. They worked prior to the update. I tested them on another amp and they worked fine. Has this been a firmware problem? Any possible solutions? Thanks.
With my phone, I have no problems at all connecting to my Code 50
I have an Android tablet that is very hit & miss connecting; at times, it will connect on first try. Other times, I have spent 25-30 minutes getting it to connect. I've gone as far as uninstalling Gateway and doing a fresh install.
Granted, it's a cheaper tablet but it shouldn't be this difficult
Hello
I am trying to find out some information on a guitar amp. My father recently passed away and left an amplifier. Due to space constraints im sadly unable to keep it and was looking for a bit of information so it can head to a good home.
It is a master model MK2 50w, serial number 00195L.
Any information would be greatly appreciated.
Thanks in advance
When I plug my Code 50 into my computer, and my DAW (Cakewalk) it either records or plays back at warp speed. I can't find anywhere in the DAW to slow it down. Is this an amp problem?
Hi, I have an issue where playing some notes in fifth octave like g5 weirdly resonates with some internals of the Amp amifying the note to unpleasant degree at the start of the note and even more couple of seconds later. Notes close to it behave normally.
This happens on both my guitars, both through the speaker and headphones on any cranked high gain Amp. My other two amps do not exhibit the same issue as well as boss gt-1000 connected to my code with ever section of it turned off.
Please help me troubleshoot this.
Obviously, I have updated to the latest firmware and did a factory reset after. However, neither of this helped.
I turned my amp off, then on again: nothing!
I tried changing the plug, leaving it on for a while, still nothing! It doesn't work anymore.
Is there a fuse?
What can I do?
Hi to everyone, how can i upload a preset. I did it once, before the update. Now i can't remmember... Please help me
Hello all
I am using a Code 25 together with a PEDL-91009 footswitch.
I would like to know if is it possible modify the volume using this pedal. I have read this thread:
(?
but it is not running, I am not getting different volume when changing the preset.
Your help is much appreciated ;-)
Kind regards,
Antonio R.
Hi,
I understand that the Code 50 can send/receive MIDI over a USB connection.
Is there a MIDI Implementation document somewhere so that I can see what commands do what?
Thanks
Mark
Hello. I recently just purchased a Marshall DSL40CR amplifier and was wondering what channel I should use when playing with my JH-F1 Fuzz Face turned on ? For additional context/information I have a Stratocaster that comes with very low output pickups ( 5.5-5.8k ) and will only be using a Wah pedal in conjunction with the fuzz face.
Пришло обновление 1.48. Начал обновлять через планшет андроид -11. На планшете дошло до 100% а на экране Code-25 показывает 97%. На планшете появляется - произошла ошибка попробуйте еще раз. Пперезагрузил повторил ещё раз результата нет. Как решить эту проблему? Как установить прошивку 1.47?
I have a FX loop foot pedal that came with the DSL40CR where do I plug it into on the back of the amp it does say FX LOOP return and send is this where I plug it into
DSL40cr . I'd like to plug in a 2x12, 4 ohm cab into the 4 ohm output and leave the existing 16 ohm internal connected to it's original 16 ohm position. Is this ok?
In other words(back of the amp) the 4 ohm cab would be far left hole, and 16 ohm internal, far right hole, all at the same time. Good to go ?
Thanks, Dan
Hi whats the best valve kit replacement for jcm 1 watt 50 th anniversary and where to buy them from
bonjour
je recherche une preconfiguration de Mission Impossible Theme de Lalo Schiffrin
pouvez vous m'aider?
Hello
I don't know if it has happened to anyone else.
The Marshall Code tuner is not very precise, having to resort to external tuners
need Metallica tones for "Black" and "Justice" album
Is there a user manual for a PEDL-91003 2-button footswitch?
I have DSL 40 valve amp (about 2 years) and it has suddenly stopped giving any sound although power is on and valves seem to be on. Any ideas?
Thanks John