After have all try, can you tell me wich phone are you sure that turns right with Getaway ?
Hi,
I have a problem with my new Stockwell II. It plays the Bluetooth connection sound while playing music with my iPad Air, which is only 10 centimeters away.
The intervall between this sounds is not constant, between 30s and 15 minutes. But quite annoying. Music playing is not interrupted.
Any ideas what to do? Maybe a firmware update? (But my windows 8.1 pc doesn't recognize the speaker.)
Thanks!!!
tenho code25 eu atualizei ele quando eu ligo ele nao aparece mais o logotipo da marschall tem algum problema.ele esta funcionando normal.
ive had a mg30cfx for a couple years now. the amp randomly cuts out every now and then. volume doesnt go over 3.... any ideas??
It's not happening always, but when it does it's frustrating. Also, sometimes the volume (when it's only cranked up around 2) it tends to get quiter than how louder it suppose to be. Should i bring it back to the shop and ask a repair?
Hi. I recently purchased a DSL40 CR and am wanting the 6 button footswitch so I can use all of the amps capabilities. Is the PEDL 91016 available yet in the US? My local Marshall dealer says that these have been back ordered for months. Currently they are telling me there is a 2 to 3 week shipment delay. What is the availability of these?
Not a lot honestly. I've had a 50 watt Marshall DSL head for about 6 years now, and it's been wonderful.
The thing is, Marshalls do the Marshall sound very well. But people do not have the space to make the Marshall come alive. Even 50 watts is way too loud to cut loose and open it up to a really nice saturated volume. To keep up with the br00tal metalz times, Marshall has been increasing the preamp gain stages. I have 4 preamp tubes in my amp, and it has way too much gain on tap. Preamp gain will always sound fizzy and harsh compared to poweramp gain, and Marshalls produce way too much volume to open up the poweramp to a nice tonal level, especially in the era of excellent PA systems and great microphones
I think that a lot of folks throw money at the problem, buying independently built amps made with period correct caps and resistors, PTP wiring, etc. But the differences are marginal at best when comparing two identical circuits (mathematically speaking) build with the types of parts used at Marshall vs. NOS stuff by indie builders. I honestly think half of the appeal is placebo effect. Players fool themselves into thinking their indie build JCM800 copy sounds sooooooo much better than a newly made JCM800 from Marshall. They're the same, any difference will come down to the speakers, microphones, PAs, and guitars used.
Hi! I have an issue while trying to transfer dowloaded presets to my Code25. It occures both usb and bluetooth connections. On a usb connection i click the “amp” icon on a preset, it’s name appears on a Code screen. I push and hold store button on amp, “saved” appears. But then Code becomes freeezed, it does not react on button push etc. when i switch it off and then switch on it works fine, preset available on amp. The same issue appears when i try to transfer presets using Gateway app. What I do wrong?
Hello everyone,,
I own both a Stanmore and a Woburn (recently), and I have never had a single issue with either. I've used the Stanmore literally daily for a few years as my main living room speaker for both streaming and AV-vinyl, and the sound and punch are both absolutely incredible. The price you've quoted sounds like a steal, and if it is in good shape I would internet cafe sweepstakes providers snatch that up. You might get the odd pop when it's turned up which can be startling when it happens, but small price to pay for tubes and quality.
I stream mainly from my laptop, and the only thing you may find is that for some reason mobile streaming from Spotify tends to be underpowered for some reason, although I had a similar issue streaming Spotify from my phone to a proper event hall AV system via aux cord so I wouldn't really fault the Stanmore for that.
Ultimately it is incredible sound and to be honest even my Sonos Play:1s have a hard time competing with a single Stanmore. The Sonos provide slightly crisper sound and the stereo is a clear advantage if that's important to you, but the Marshall sound is warm with deep powerful bass that easily makes up for some of the clarity loss (and I really can't stress enough that unless you're an audiophile and actually sit and compare them in an intense back and forth, you would have a hard time deciding which is better - I actually prefer the Stanmore for certain types of music).
I hope that helps and let me know if you have any questions!
Hello,
I am experiencing some troubles with the battery of my speaker stockwell that I bought 2 years ago.
I would like to know the contact phone number of the technical service in Valencia (Spain).
Thanks.
Dear all,
I am experiencing some trouble with my Minor II headphones, as they do not connect anymore. Tried to pair them again, but they do not appear on my iPhone (7).... when switching on, the white light constantly flashes to green, but I cannot find any info about a green light.
I'm looking for some good "Shadows" tones like Apache, FBI and so on. Are they available somewhere?
Thanks for Your response, but i wanted To insist that popping Is not produced by the buttom, it is through The MX 212a speaker's cabinet, i have compared To other amps DSL And don't have this problem. Please help me..
Hello All,
What cable does someone use to hook up their ipad to a Code 50? it would a lightning to a ???
And why does one need a cable to hook up to the Code? if the Code is synched via blutooth then anyhting on the APP, such as updates or presets, should also be able to get tot he Code via the blutooth and not need a cable. Could this be a glitch on Marshall's end or they just never programmed it into the software to do it. Seems like an oversight, no?
Thanks for any help anyone can give,
Lou
Does anyone know of a good preset that would sound like the song “I’m Alright” by Neil Zaza?
Hi,
I have had my code 25 for about 6 months and for a while now, everytime I connect my phone and edit in the gateway app the preset freezes and I cannot change anything or change the preset. On the phone it says I am changing but there is no actual changes happening. On the little orange screen on the actual amp it stays on that preset even if I twist the knob to change preset but can still play and change volume.
TodayI was getting sick of it and looked up if there are updates for the amp and there are, which I then went and installed the latest firmware update. But now when I turn on the amp it shows that it's on and shows the preset but stays frozen and will not play sound at all. Is the amp done or can it be fixed?
a month ago I bought my dsl 20hr, and i have an Excessive popping when switching channels .. it is normal ? please help me...
Hello mates! I just bought the awesome Marshall Code 50. I'm just wondering how you can organize your own presets in a specific order (and in what presets should you store them all), so you may have for example your very own organized preset: Rhythm preset - Lead preset - Clean preset - Crunch preset.
That being said, can you move factory presets to other spots to organize them at your convenience too?
Thank you mates!
WM♫
Hi!
I have had this Super Lead for 18 years or something and haven´t given the age much thought but the other day it just hit me that this has to be a Plexi and therefore it would be nice to maybe get to know what year it's made.
Serial no. SL/ 10780
